Fórum - Téma


Maverick * Kodování dálkového ovladače


Fórum Technický koutek Maverick * Kodování dálkového ovladače




2012-11-28 23:00:33

Ahoj poraďte mi prosím jak nakodovat DO u maverika r.v. 1996 nějak mi to nejde.

Diky Tomáš

Etli, 2012-11-28 23:00:33 napsal:

Ahoj poraďte mi prosím jak nakodovat DO u maverika r.v. 1996 nějak mi to nejde.

Diky Tomáš

2012-11-29 11:19:40

Ahoj , tady bys to nenašel?

http://www.fordclub.eu/fo...i-dalkoveho-ovladani-1892

2012-12-01 17:11:19

jdu tam mrknout , díky

2012-12-19 19:50:23

Tady je návod. Je sice anglicky.

Maverik 2005(08/2004-)

UTION: All remote transmitters must be programmed at the same time.

1. The vehicle must be electronically unlocked before entering program mode (via remote transmitter, keyless entry keypad (if equipped) or door lock control switch while the driver door is open.

2. Turn the key from OFF to RUN 8 times within 10 seconds, with the eighth turn ending in RUN. If the module has successfully entered program mode, it will lock and then unlock all doors.

3. Within 20 seconds, press any button on a remote transmitter, and the doors will lock and then unlock to confirm that each remote transmitter has been programmed. Repeat this step for each remote transmitter.

4. If the door locks do not respond for any remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Inspection and Verification. Make sure that no more than the maximum number of remote transmitters are attempted to be programmed.

5. Exiting the programming mode is accomplished if one of the following occurs:

The key transitions to the OFF position.

20 seconds have passed since entering programming mode or since the last remote transmitter was programmed.

The maximum number of remote transmitters have been programmed.

Maverik 2001(12/2000-07/2004)

General Procedures

  • NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.
  • NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
  • NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), carry out the following steps.

1. Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.

2. NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met.

Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.

3. If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.

4. Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.

2012-12-19 20:19:18

nefunguje to


Odpovědět